Draining And Cleaning Intex Pool

Set up your garden hose to an area where you want the drained pool water to go to.

Draining and cleaning intex pool.

This is on the bottom inside your intex pool. It might take a while for the water to drain usually it will take two to 3 hours to drain the whole hot tub completely. This method of siphon draining your pool can also be done with a pool vacuum hose. Locate the drain valve on the outside of the pool and remove the cap.

You ll simply immerse the entire hose in the water and then while covering one end with your hand quickly pull that end out of the pool and point it downward below the pool surface. Connect a garden hose plug them in and carefully place the pump in the bottom of the pool near the edge. Connect your hose adapter to your garden hose and then connect this to your drain valve to start draining your pool water. If you choose not to cut the hose you ll need to attach the hose to your spigot and fill it completely with water.

Thoroughly rinse and drain any leftover water. Wipe down the inside of your intex pool with a soft cloth warm water and mild cleaner. Connect the pool wall brush to a telescoping shaft if not already assembled similar to what would be used for a pool skimmer or the intex pool vacuum. 2 scrub the walls and floor of the pool.

Remove the cap in your intex framed pool set. Step 2 place a hose on the ground with the female end lying next to the pool near the drain valve and the male end in an area where water can safely be emptied. Avoid the hassle expense of buying a 20 adapter to drain your above ground ring pool. This is usually located on the bottom inside your hot tub.