Cutting Countertop For Undermount Sink

Wood countertop with undermount sink.

Cutting countertop for undermount sink.

I ll have to sand and finish the edges once i cut the hole. There are numerous ways to create a straight rigid edge. Drop in sinks are also called top mount or self rimming sinks. Luckily my sink came with a template that made this task super easy.

How to cut a counter for a kitchen sink. Undermount sinks drop in sinks and farmhouse sinks. So the total cost for the butcher block itself was 780 which is a decent chunk of change but for the end result totally worth it. The hidden edge of the undermount sink has an attractive streamlined appearance and the lack of crevice or a lip makes the edges less likely to catch dirt.

An undermount sink as the name suggests is a sink that is mounted underneath a countertop in a kitchen or other room. When you purchase a new sink there s always instructions and a. I wanted my subset to be covered by the countertop though because we were using our existing sink and it had holes from previous hardware the sprayer and knobs that weren t needed for our. When i remembered that i needed a hole for my sink i temporarily discontinued my finishing efforts.

Usually double basin undermount sinks have just one hole in the counter so the subset dividing area between sinks is not covered by the countertop. There are three main types of sinks. Once the countertops were cut and dry fit to the cabinets and walls it was time to cut the sink hole. Cutting out a hole for the sink.

Adhesive is injected between the sides of the sink and counter. Extra cutting tool blades. Undermount sinks are installed below the countertop. Cutting a sink opening into a countertop can seem intimidating but it s straightforward.

For the pedraza kitchen it required an 8 foot countertop and a 12 foot countertop. Drop in sinks are mounted to the top of the counter top. These sinks have a rim that rests on top of. The counter is cut to accommodate the sink and the sink set inside with the rim flush to the laminate.

Then the laminate is cut away routed and sanded for a consistent transition and a seamless undermount sink. To cut a hole for a sink it s easiest to use a jigsaw which allows for great control.